The work we do
24 years on luxury appliances means most diagnoses take minutes, not visits. Here is the work we do every week, and the signs it’s time to call.
When is it time for a repair?
Five signs worth a call.
Temperature fluctuations
Food spoiling early or a freezer that won’t hold cold, often a failing thermostat or compressor.
Unusual noise
Grinding, buzzing, or clicking from an appliance built to run quietly points to a motor on its way out.
Water leaking
Puddles beneath a refrigerator, washer, or dishwasher usually mean a clogged drain or a compromised line.
Frost buildup
Excess ice in the freezer traces back to a defrost system fault or a tired door gasket.
Lights or display out
A dark interior or a blank panel can signal an electrical fault well beyond a burned out bulb.
Refrigeration · Every brand
Refrigeration repairs
Refrigerator not cooling
Temperature drift, warm zones, or food spoiling early. Usually a failing compressor, sealed system, or control fault.
The full storyIce maker not making ice
No ice, low production, or leaks at the water inlet valve, diagnosed and repaired in one visit.
The full storyWater leaking from the bottom
A clogged defrost drain or a split water line, traced to the source and sealed properly.
The full storyHeavy frost buildup
Excess ice in the compartment traces back to a defrost heater, a sensor, or a tired door gasket.
Door not sealing
A worn gasket lets cold escape and runs the compressor hard. We restore airtight seal integrity.
Buzzing and loud operation
Grinding or buzzing from a unit built to run quietly is a fan motor or compressor calling for attention.
Wine and beverage storage
Dual zone drift and humidity faults that threaten a cellar, recalibrated to spec.
Cooking · Every brand
Cooking repairs
Oven won’t heat or hold temp
Failed igniters, elements, and sensors restored for consistent, calibrated baking heat.
The full storyBurner won’t light or clicks
Continuous clicking and spark module faults on sealed gas burners, corrected.
The full storyCooktop zones not heating
Dead induction zones and radiant elements diagnosed at the module and restored.
The full storyUneven baking
Convection fan motor failures and airflow faults that cook one side faster than the other.
Touch panel and display errors
Unresponsive touchscreens and digital error codes diagnosed at the board level.
Door and gasket heat loss
Hinge tension and gasket seals restored so the oven holds its heat where it belongs.
Brands we service
Every brand has its own habits. We know them all.
Each brand fails in its own way, and each has a dedicated page with the faults we see most and how we put them right.
Dishwashers · Every brand
Dishwashers repairs
Not draining
Standing water after a cycle points to a drain pump, a check valve, or a blocked filter.
The full storyNot cleaning or spotting
Circulation pumps, spray arms, and dispensers restored so glassware comes out flawless.
Leaking at the door
Door gaskets, hinges, and float switches sealed and adjusted before floors are damaged.
Error codes and dead panels
Control board and sensor faults read properly and corrected at the source.
Racks, latches, and hinges
The touch points that wear first, restored with genuine parts.
Laundry · Every brand
Laundry repairs
Washer not draining
Water left in the drum after a cycle. Drain pumps, filters, and hoses cleared and replaced.
The full storyDryer not heating
Tumbling cold, or taking two cycles to dry. Elements, igniters, and airflow restored.
The full storyDrum noise and vibration
Bearings, rollers, and suspension faults corrected before they take the motor with them.
Door locks and latches
A washer that will not lock or a dryer door that will not stay shut, repaired properly.
Error codes and controls
Modern laundry is computer controlled. We read the fault correctly the first time.
We fix it all