Washers in Los Angeles
A washer in a Los Angeles home rarely gets a day off, cycling through work clothes, school uniforms and beach towels in a city where nobody waits for laundry day. We handle every configuration, front load and high efficiency top load machines from LG, Samsung, Whirlpool and Maytag, compact 24 inch and stacked units from Bosch and Asko in apartments from Santa Monica to Silver Lake, and pedestal drawers beneath them. Across 24 years we have learned how each platform drives, drains and spins, and the exact points where each wears out first.
A washer that stops mid cycle could have a blocked drain pump, a failed door lock or worn tub bearings, and those repairs are priced worlds apart while the machine shows the same blinking code for each. Replacing parts until the noise stops is the most expensive way to fix a washer. Our diagnostic visit is $95, waived with your repair, and it ends with a firm written quote before any work begins. Plenty of repair bills grow once the cabinet is open. Ours do not. The number you approve is the number you pay.
We are open daily from 7am to 7pm, with same or next day appointments across Los Angeles and Southern California. One call brings a factory trained technician with common washer parts on the truck, from pumps to door locks, so most machines finish a full cycle before we leave. Precise diagnosis, genuine parts, and a 3 Year Onyx Warranty in writing.
What we fix
What fails inside a washer.
Drain pumps and blocked pump filters
A drum that will not empty or a hum at the end of the cycle usually traces to the drain pump or a coin packed filter. We clear the filter, test the pump under load and replace it when the impeller or winding has failed.
Drive motors, stators and rotor position sensors
A washer that fills but never turns the drum, or shudders and quits early in agitation, often has a failed stator, worn motor brushes or a rotor position sensor feeding bad data. We test the windings and sensor signals, then replace the failed part.
Tub bearings and spider arms
A roar that grows louder every month during spin means the tub bearings are dying, and on front load machines a corroded spider arm often goes with them. We open the tub, replace bearings, seal and spider together and return the spin to quiet.
Door locks, lid switches and latch assemblies
A front load door that will not release, or a top load machine that refuses to start with the lid closed, points to the lock assembly or lid switch. We test the lock circuit, free a trapped load safely and replace the failed assembly.
Water inlet valves and dispensers
Slow filling, detergent left sitting in the drawer or a machine that fills while switched off all point to the inlet valves. We test each solenoid, check screens for sediment common in Los Angeles water and replace valves that stick open or closed.
Suspension rods, dampers and shock absorbers
A washer that walks across the floor or bangs the cabinet during spin has worn suspension, not an unbalanced load. We test each rod and damper for lost resistance, replace them as a set and confirm the drum runs true at full speed.
Control boards and user interfaces
A dead panel, a cycle that stops at the same minute every time or buttons that answer randomly sit at the board level. We read the error codes, test inputs and outputs at the connector and replace the board with a genuine OEM part.
Leaks at the door boot, tub seal and hoses
Water on the floor after a wash traces to a torn door boot, a weeping tub seal or a split internal hose, and each leaves its own trail. We pressure test the path, replace the failed seal and run a full cycle to confirm dry.
A leak, a roar and a stalled cycle can each hide several different causes, which is why guesswork costs so much on washers. A factory trained Onyx technician confirms the actual failure with testing, repairs it once with genuine OEM parts and stands behind the work with a 3 Year Onyx Warranty in writing.
Why it cannot wait
A washer that fails mid cycle leaves water behind.
A drum full of standing water starts to sour within a day, and a slow leak under the machine finds hardwood and baseboards before anyone sees it. Hauling wet laundry to a laundromat costs time and money every day the washer sits broken. A same or next day repair stops the damage while it is still small.
Request a visit
Tell us what it is doing.
Four details and we will call you back with an arrival window, usually the same day. One quote before any work begins, and the $95 diagnostic is waived with your repair.
Why Onyx
The care your kitchen deserves.
Factory trained specialists
Vetted, uniformed technicians certified across every major luxury appliance brand.
Genuine OEM parts
Only genuine components for the brand we are servicing, sourced direct. No aftermarket substitutes.
White glove home protection
Floors, stone, and cabinetry are draped and protected before a single panel comes off.
$95 diagnostic, waived with your repair
One flat diagnostic visit. Go ahead with the repair and the diagnostic costs you nothing.
Concierge scheduling
One point of contact, arrival windows kept, and updates by text or call, whichever you prefer.
Licensed and insured
Bonded and fully insured on every visit. Documentation ready on request.
Questions, answered
Before you call.
How much does washer repair cost in Los Angeles?
The diagnostic visit is $95, waived with your repair. Once the fault is confirmed you receive a firm quote for parts and labor before any work begins, and the amount you approve is the amount on your invoice.
Can you come out today?
Usually, yes. We are open daily from 7am to 7pm, with same or next day appointments in most of Los Angeles and Southern California, and a washer holding a load of water moves up the list. Call (747) 777-9728 for an honest arrival window.
Which washer brands do you repair?
All major brands, including LG, Samsung, Whirlpool, Maytag, GE, GE Profile, Electrolux, Frigidaire, Bosch, Asko, Fisher & Paykel and Amana, from compact 24 inch machines to full size stacked pairs. Onyx is an independent company, not affiliated with any manufacturer.
Is my washer worth repairing?
Often, yes. A pump, lock or valve repair costs a fraction of replacement and restores years of service. When tub bearings fail on an older machine and the repair approaches the price of a comparable new washer, we tell you so plainly.
What warranty comes with the repair?
Every repair carries the 3 Year Onyx Warranty covering parts and labor, in writing. If the fault returns within that period, so do we, at no charge.
Will the price change once you open it up?
No. One Quote. One Price. Guaranteed Repair. No Supplemental Estimates. The written quote you approve after diagnosis is final, and when a repair turns out to demand extra hours or an extra part, we absorb that cost rather than pass it to you.
The Onyx guarantee
The 3 Year Onyx Warranty, parts and labor, in writing.
A $95 diagnostic, waived with your repair, and 24 years on luxury appliances behind every visit.
Other appliances we service
Something else acting up?
See every appliance we repair across Los Angeles & Southern California.
Already know the fault? We have full pages on Washer not draining.
Same day service · Los Angeles & Southern California
Your peace of mind is one call away.
One number, and it is handled, from diagnosis to a kitchen that simply works again.
$95 diagnostic, waived with your repair.